EVO Bluetooth Dimmer

More about EVO Bluetooth Dimmer

This Bluetooth dimmer is compatible with EVO-series grow lights only. One Bluetooth dimmer is required for each lamp that should be dimmed. 

• Dimming possible with 1% increments, ranging from 20% to 100%;
• Dim individual lamps or groupings;
• Manual operation is possible with magnetic key;
• Ability to dim to Off (EVO series only);
• Operatable up to 3.200 luminaires with the SANlight Mesh App;
• Free software updates for further developments;
• Stealth mode available;
• Spray-proof (IP65 protection).

Manual

1. Install the SANlight Mesh App in the Google Play Store or the Apple App Store (free of charge).
2. Connect to the Bluetooth dimmers with the app by going to "Settings" in "Options" then click on "Firmware Update".
3. Wait for a few minutes before all dimmers are displayed. Once displayed, select them and click on the "update" button. Once completed, confirmation is send to the app and the dimmers. 
4. After the update, reset the dimmers with the magnetic key by holding the red side near the dimmer for 5 seconds. This step is successful when the red LED light on the dimmer blinks and when the lamp switches itself off and on again.
5. Disconnect the dimmers from the power supply for 10 seconds by either disconnecting the dimmer from the lamp or to unplug the entire set of lights from the power supply. 
6. Once the red LED light is turned off, wait another 5 seconds before reconnecting the power supply. Now all of your dimmers are fully updated. This is indicated by the orange LED light turned on and the green LED light flashing.
7. Click on "SANlight Mesh" in the tab and then on "add device". Here you can see from the name that the dimmer are on the latest version. 
8. Select your dimmers and click on "Add to mesh". Now all dimmers with the latest firmware are integrated in your mesh and are now operatable from the app at the same time.